Engineering, 16.03.2020 22:13 HeroicEddie

(25 points).The heat is turned on in a building in a cold morning, but the heater does not burnthe natural gas properly and emits carbon monoxide (CO) at 55mg/hr. CO is detrimental tohumans at concentrations of 5 ppm or higher. If the ventilation of the building is refreshing the air(i. e., it brings fresh air from outside that contains no CO at a flow rate of 100 m3/hr, the buildinghas a volume of 500m3, and CO is slowly oxidized in the air to carbon dioxide (CO2) with a rateconstant of kd=0.0001mg. L-1.hr-1, will the COconcentration ever pass the 5ppm limit or not?Atomic weights: C-12, O-16, air-29; 1 mole of gas occupies 22.4L at the conditions of theproblem (1atm, 250C).

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

You know the right answer?

(25 points).The heat is turned on in a building in a cold morning, but the heater does not burnthe n...

Questions