subject
Engineering, 14.03.2020 19:14 ASTROBOY1

Telonal (1)
A trag tower is to be wed to remove 30% of
the ammonio from an entering air Steam
containing 0.089 mol ammonia lool inert air
at 298k and Tatm. The entering pare How
water is 10kgmol Hâ‚‚O1hr and the inext air
flow is 18.5 ich mol air/hr.
a Calcalale the composition of frented w and
ased cuater.
b. Plot the operating lines on xy (matraction)
graphs.
valor flow
minimum
e
Calculate
the
theoretical
rate.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
question
Engineering, 06.07.2019 02:30
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
question
Engineering, 06.07.2019 04:10
Aspherical thermocouple measurement errors a spherical thermocouple made of constantin transfer coefficient between the gas and the thermocouple is h used to measure the temperature of a gas. the heat 400 w/m2 k. calculate the maximum diameter d of the thermocouple if the thermocouple's measurement error should be w 23 within 5% of the initial temperature difference in 5 seconds. for constantin, k 8920 kg/m3, and c 410 j/kg. k.
Answers: 3
You know the right answer?
Telonal (1)
A trag tower is to be wed to remove 30% of
the ammonio from an entering air St...
Questions
question
History, 30.09.2019 17:30
Questions on the website: 13722362