Engineering, 14.03.2020 02:43 lekaje2375

A. Choose resistor values R1 and R2so that the DC drain current value is ID1= 100 μA. Assume for this calculation thatλ effects are negligible, i. e., λ≈ 0 V−1. B. For the remaining parts of the problem, consider |λn| = |λp| = 0.01 V−1. It is desired to have the DC output voltage value VO = 5 V. Find the ratio of ID2 to IREF for this case. C. Again considering the DC output voltage value to be VO = 5 V, what is the maximum ac output voltage swing (peak-to-peak) without there occurring significant waveform clipping (i. e., the output voltage range over which Q1 and Q2 remain in saturation)?D. Construct a small-signal equivalent circuit for the amplifier that is appropriate for determining the voltage gain, vo/vi. Clearly identify relevant components and device terminals. E. Solve for the amplifier circuit’s small-signal voltage gain, vo/vi. Begin by writing an expression for the gain, and then determine its value.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

You know the right answer?

A. Choose resistor values R1 and R2so that the DC drain current value is ID1= 100 μA. Assume for thi...

Questions