Engineering, 13.03.2020 19:43 SuBzErO24

A cylindrical metal specimen 12.7 mm (0.5 in.)
in diameter and 250 mm (10 in.) long is to be
subjected to a tensile stress of 28 MPa (4000
psi); at this stress level the resulting deformation
will be totally elastic.

If, in addition, the maximum permissible diameter
decrease is 1.2 103 mm (4.7 105 in.)
when the tensile stress of 28 MPa is applied,
which of the metals that satisfy the criterion in
part (a) are suitable candidates? Why?

*( part a was : If the elongation must be less than 0.080
mm (3.2 103 in.), which of the metals in
Table 6.1 are suitable candidates? Why? )

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Areheat rankine cycle operates with water as the working fluid. steam enters the first turbine at 8 mpa and 450°c and exits at 0.8 mpa. it is then reheated to 400°c before entering the second turbine, where it exits at 10 kpa. if the amount of work into the pump is 8.04 kj/kg and the net work per cycle produced is 1410.25 kj/kg, determine the thermal efficiency of the cycle.

Answers: 3

Answer

You know the right answer?

A cylindrical metal specimen 12.7 mm (0.5 in.)
in diameter and 250 mm (10 in.) long is to be

Questions