subject
Engineering, 13.03.2020 03:43 quetzaliescalona

The following waveforms are measured through a particular device: LaTeX: v(t)= 20\cos(100t+50^{\circ})Vv ( t ) = 20 cos ⁡ ( 100 t + 50 ∘ ) V LaTeX: i(t)=15\cos(100t-5^\circ)Ai ( t ) = 15 cos ⁡ ( 100 t − 5 ∘ ) A What is the power angle? Submit your answer in degrees, while omitting the unit.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 19:10
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
question
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
The following waveforms are measured through a particular device: LaTeX: v(t)= 20\cos(100t+50^{\circ...
Questions
question
Computers and Technology, 08.06.2021 01:00
Questions on the website: 13722361