Engineering, 11.03.2020 01:20 charlesiarenee0

How do I design a BCD to seven-segment decoder using a single decoder and OR gates only?

Where,
The desired decimal digit is expressed in binary-coded-decimal (BCD) format, and then used as an input to a logic network which controls the seven segments.

For this project, you will develop a multiple-output logic network that drives a 7-segment display, yielding all ten decimal digits. Here is how you will proceed:

1. The input variables will be the BCD representations of the decimal digits 0-9 (use switches 0-3 on your board: SW0= LSB, SW3= MSB).

2. Using Karnaugh maps, determine the seven output functions for controlling each of the seven segments, in minimum SOP form. Using Don't Cares will greatly simplify your output functions.

3. Express the seven output functions

4. You will display the digit on the left 7-segment digit on your board. Refer to the manuals regarding how to enable a specific digit on this display. Hint: Applying a logic low level to a segment causes it to light up and applying a high level turns it off.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acommercial grade cubical freezer, 4 m on a side, has a composite wall consisting of an exterior sheet of 5.0-mm thick plain carbon steel (kst= 60.5 w/m k), an intermediate layer of 100-mm thick polyurethane insulation (kins 0.02 w/m k), and an inner sheet of 5.0- mm thick aluminium alloy (kal polyurethane insulation and both metallic sheets are each characterized by a thermal contact resistance of r 2.5 x 104 m2 k/w. (a) what is the steady-state cooling load that must be maintained by the refrigerator under conditions for which the outer and inner surface temperatures are 25°c and -5°c, respectively? (b) for power saving purpose, which wall material should be increased/reduced in. thickness in order to reduce 50% of the cooling load found in part (a)? redesign the thickness of the proposed material. 177 w/m-k). adhesive interfaces between the q=575.93 w

Answers: 2

Answer

Engineering, 04.07.2019 19:20

List 3 options on how to reduce knocking problens during engine process,

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

Answer

You know the right answer?

How do I design a BCD to seven-segment decoder using a single decoder and OR gates only?

Questions