Engineering, 07.03.2020 01:34 jjackson0010
(TCO 7) A single output device has failed while the remainder of the PLC system is functioning normally. The indicator light on the output module indicates that a signal is being sent to the output point where the device is connected. Technician A says you would next trace the circuit back through the logic to locate the input(s). Technician B says you would next check the point where the output device's field wiring is connected to the output rack. Who is correct
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
(TCO 7) A single output device has failed while the remainder of the PLC system is functioning norma...
Questions
Computers and Technology, 03.07.2019 20:00
French, 03.07.2019 20:00
History, 03.07.2019 20:00
English, 03.07.2019 20:00
Mathematics, 03.07.2019 20:00
Spanish, 03.07.2019 20:00
History, 03.07.2019 20:00
Social Studies, 03.07.2019 20:00
English, 03.07.2019 20:00
