Engineering, 07.03.2020 00:04 ggpro4life3000

A 2A-liter, four-cylinder engine is equipped with multipoint port fuel injection, having one injector per cylinder. The injectors are constant-flow devices, so the fuel flow rate into the engine is controlled by injection pulse duration. Maximum power is obtained at WOT when injection duration is continuous. At this condition, engine speed is 5800 RPM with stoichiometric gasoline and an inlet pressure of 101 kPa. At idle condition, the engine speed is 600 RPM with stoichiometric gasoline and an inlet pressure of 30 kPa. Volumetric efficiency can be considered 95% at all conditions. Calculate: (a) Fuel flow rate through an injector. [kg/sec] (b) Injection pulse duration in seconds at idle conditions. (c) Injection pulse duration in degrees of engine rotation at idle conditions.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 06.07.2019 03:10

List and describe the attached tools in boxford cnc milling machine? and how many tools were used in your projects explain them?

Answers: 3

Answer

You know the right answer?

A 2A-liter, four-cylinder engine is equipped with multipoint port fuel injection, having one injecto...

Questions