Engineering, 06.03.2020 23:52 wetogether0123
A charge of 11.748 nC is uniformly distributed along the x-axis from −2 m to 2 m . What is the electric potential (relative to zero at infinity) of the point at 5 m on the x-axis? The value of the Coulomb constant is 8.98755 × 109 N · m2 /C 2 . Answer in units of V
Answers: 3
..............1
Another question on Engineering
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
You know the right answer?
A charge of 11.748 nC is uniformly distributed along the x-axis from −2 m to 2 m . What is the elect...
Questions
Mathematics, 20.04.2020 21:11
Mathematics, 20.04.2020 21:11
Mathematics, 20.04.2020 21:11
Mathematics, 20.04.2020 21:11
Biology, 20.04.2020 21:11
Mathematics, 20.04.2020 21:11
Computers and Technology, 20.04.2020 21:11
