Engineering, 06.03.2020 22:38 potatoismeh1
The total solidification times of three casting shapes are to be compared: (a) a sphere with diameter = 10 cm, (2) a cylinder with diameter and length both = 10 cm and (3) a cube with each side = 10 cm. The same casting alloy is used in the three cases. (a) Determine the relative solidification time for each geometry. (b) Based on the results of part (a), which geometric element would make the best riser? (c) If Cm = 3.5 min/cm2 in Chvorinov’s Rule, compute the total solidification time for each casting.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
The total solidification times of three casting shapes are to be compared: (a) a sphere with diamete...
Questions
Engineering, 24.11.2020 14:00
English, 24.11.2020 14:00
Advanced Placement (AP), 24.11.2020 14:00
English, 24.11.2020 14:00
Chemistry, 24.11.2020 14:00
Mathematics, 24.11.2020 14:00
Mathematics, 24.11.2020 14:00
Computers and Technology, 24.11.2020 14:00
Mathematics, 24.11.2020 14:00
