subject
Engineering, 06.03.2020 00:23 daliakreynin

The pressure distribution over a section of a two-dimensional wing at 4 degrees of incidence may be approximated as follows: Upper surface: Cp constant at – 0.8 from the leading edge to 60% chord, then increasing linearly to +0.1 at the trailing edge. Lower surface: Cp constant at – 0.4 from the leading edge to 60% chord, then increasing linearly to + 0.1 at the trailing edge. Estimate the lift coefficient and the pitching moment coefficient about the leading edge due to lift.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
You know the right answer?
The pressure distribution over a section of a two-dimensional wing at 4 degrees of incidence may be...
Questions
question
Mathematics, 22.04.2020 23:26
question
Mathematics, 22.04.2020 23:26
question
Geography, 22.04.2020 23:26
Questions on the website: 13722367