subject
Engineering, 05.03.2020 21:53 SmokeyRN

A car is traveling at 70 mi/h on a level section of road with good, wet pavement. Its antilock braking system (ABS) only starts to work after the brakes have been locked for 100 ft. If the driver holds the brake pedal down completely, immediately locking the wheels, and keeps the pedal down during the entre process, how many feet will it take the car to stop from the point of initial brake application? (The braking efficiency is 80% with the ABS not working and 100% with the ABS working. Use theoretical stopping distance and ignore air resistance. Let frl = 0.02 when the brakes are locked, but compute the frl once the ABS becomes active.)

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
You know the right answer?
A car is traveling at 70 mi/h on a level section of road with good, wet pavement. Its antilock braki...
Questions
question
Chemistry, 08.10.2019 15:20
question
Social Studies, 08.10.2019 15:20
Questions on the website: 13722362