Engineering, 05.03.2020 19:59 miguelc2145
A steel loop ABCD of length 5ft and of 3/8" diameter is placed as shown around a 1" diameter aluminum rod AC. Cables BE and DF each 1/2" diameter are used to apply the load Q. Knowing that the ultimate strength of the steel used for the loop and the cables is 70ksi and that the ultimate strength of the aluminum used for the rod is 38ksi. Determine the largest load Q that can be applied if an overall factor of safety of 3 is desired.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
You know the right answer?
A steel loop ABCD of length 5ft and of 3/8" diameter is placed as shown around a 1" diameter aluminu...
Questions
Mathematics, 24.07.2019 22:00
