This assignment covers the sequential circuit component: Register and ALU. In this assignment you are supposed to create your own storage component for two numbers using registers. Those two numbers are then passed into a custom ALU that calculates the result of one of four possible operations. Key aspect of this assignment is to understand how to control registers, how to route signals and how to design a custom ALU.

The part I called command in the first diagram has been renamed to opcode, or operation code. This is a set of bits (a number) that will tell the ALU which action to perform. I can get the LC-3 opcodes for ADD and NOT and ADD from the book, so I'm not too worried.

Note the #? comment by the switch above opcode. This means I'm not sure how many switches I will need. How many bits do I need to perform all the operations I want? The textbook will tell me.

Materials

Now I make a list of all the materials you have accumulated so far. This list is just an example; yours may be different.

Two 4-bit inputs

One 4-bit output

Two keypads for 4-bit input

Three 7-segment displays (2 for input, 1 for output)

A bunch of switches for opcode (could use a keypad, I guess, but switches are so much more geeky)

A bunch of lights too

The "is zero" LED

One button for clock

One button for reset

One switch for carry-in

Include logic to perform a SUB instruction. That is, subtract the second operand from the first (out = in1 - in2). All three values -- both inputs and the output -- must be two's complement numbers (negative numbers must be represented). Your design may work in one (8 points) or two (4 points) clock cycles.

Explanation:

You are allowed to use the Logisim built-in registers.

The clear input of the register should not be used (do not connect anything to

them).

Custom ALU

Use the provided subcircuit in the template to implement your ALU. You do not have to create additional subcircuits to do this. The ALU has a total of three inputs: First number, second number and select operation input. And one output: Result. The first and second number are used as input for the operations the ALU performs. The select input decides which operation result will be on the single output of the ALU. The ALU is supposed to calculate: NumberA OPERATION NumberB. Register 1 of the storage contains NumberA and Register 2 contains NumberB. The ALU must be able to compute signals with a 4-bit width. Make sure to add labels to all inputs and outputs.

The following operations should be performed for each select input combination (s1s0): • 00: Logic Bitwise XOR

• 01: Multiplication

• 10: Division

• 11: Addition Notes:

You can change the inputs bit width / data bits of any gate to more that 1-bit.

The Logic Bitwise XOR operation can be done with a single XOR gate.

You are also allowed to use the built-in arithmetic logic components and multi- plexer provided by Logisim.

If the result is larger than 4 bits, it will be truncated (only 4 LSB will be shown). This behavior is intended for this assignment. Also, negative results do not have to be considered.

Once you have implemented the ALU circuit, connect the wires in the main circuit properly and test all four operations of your ALU in combination with the storage component.

answer:

the fed will purchase bonds from banks to inject money into the banking system. the banks can use these funds to provide loans to individuals and businesses.

explanation:

answer: excel provides a method to add or to remove borders around and between cells. instead of selecting cells first and then formatting, you can choose the formatting tool that you want to use, and then apply the format to one or more cells.

explanation: plz brainliest,im 1 more brainliest from ranking up< hop icould