subject
Engineering, 03.03.2020 17:54 daniii000

A total of 725 auto-mode social/recreational trips are made from an origin (residential area) during the peak hour. A logit model estimation is made, and three factors were found to influence the destination choice: (1) population at the destination, in thousands (coefficient - 0.17); (2) distance from origin to destination, in miles (coefficient-.0.23); and (3) square feet of amusement floor space (movie theaters, video game centers, etc.), in thousands (coefficient- 0.10). Four possible destinations have the following characteristics: Population (thousands)Distance from origin Amusement space Population (thousands) (thousands of ft') 7.5 Destination 1 Destination 2 Destination 3 Destination 4 (mi) 15.5 6.0 0.8 5.0 10 2 15
(a) Determine the distribution of trips among possible destinations.
(b) If the total number of trips remains constant, determine the amount of amusement floor space that must be added to destination 2 to attract an additional 50 social/recreational trips.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
question
Engineering, 04.07.2019 19:20
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
question
Engineering, 06.07.2019 02:30
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
You know the right answer?
A total of 725 auto-mode social/recreational trips are made from an origin (residential area) during...
Questions
question
Mathematics, 26.02.2020 04:20
question
Mathematics, 26.02.2020 04:20
Questions on the website: 13722361