Engineering, 02.03.2020 21:21 rosyjesus297

G You are given three iron rods. Two of them are magnets but the third one is not. How could you use the two magnets to find that the third rod is not magnetized? The two magnets will be attracted to one another. The iron bar that is not attracted to either of the other magnets is, therefore, not magnetized. It is impossible to determine which of the iron rods are not magnetized. Use both ends of one iron rod to approach the other iron rods. If both ends of the rod you are holding repel both ends of the other two rods, then the one you are holding is not magnetized iron. Use both ends of one iron rod to approach the other iron rods. If both ends of the rod you are holding attracts both ends of the other two rods, then the one you are holding is not magnetized iron.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

You know the right answer?

G You are given three iron rods. Two of them are magnets but the third one is not. How could you use...

Questions