Engineering, 27.02.2020 21:44 hejdiidid9311

On a breadboards, hook up an IR LED to provide an infrared light source for signaling the phototransistor as shown in Figure 2 below. Use a pushbutton switch to turn the IR LED on and off. Note that the pushbutton does not require any resistors to ground as it only needs to control when the power enters the power rails on your protoboard. The IR LED will drop approximately 1.35 volts and should be operated with ~100 mA of current.

Q1: Calculate the value required for the resistor labeled R in the circuit below to achieve these design specifications.
Q2: Now calculate the power that you expect this resistor to absorb (remember the formulas for power in terms of current and resistance)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

On a breadboards, hook up an IR LED to provide an infrared light source for signaling the phototrans...

Questions