Engineering, 27.02.2020 19:28 Csoard2004

A rod made of 60-40 brass is sliding over unlubricated hardened tool steel with a load of 320 N. The hardness of brass is 520 MN/m2. The wear co-efficient is 10-3. Find: a. The distance traveled to produce a wear of volume of 0.01 mm3 by the adhesive wear of the brass rod. b. The distance traveled, if additional load of 0.0069 kN is applied and a wear volume 7 mm3

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window

Answers: 3

Answer

You know the right answer?

A rod made of 60-40 brass is sliding over unlubricated hardened tool steel with a load of 320 N. The...

Questions