Engineering, 27.02.2020 19:15 jdkrisdaimcc11

B is the desired product, and X and Y are foul pollutants that are expensive to get rid of. The specific reaction rates are at 27C. The reaction system is to be operated at 27C and 4 atm. Pure A enters the system at a volumetric flow rate of 10 dm3/min.

(a) Sketch the instantaneous selectivities (SBAoSB/Y, and SBXY-ry(rxtrY)) as a function of the concentration of CA
(b) Consider a series of reactors. What should be the volume of the first reactor?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

You know the right answer?

B is the desired product, and X and Y are foul pollutants that are expensive to get rid of. The spec...

Questions