Engineering, 26.02.2020 05:21 jtroutt74

A 50 kbps satellite channel is used to transmit 1000-bit frames between Sophie in Moscow and Richard in New York. Assume that the distance between Richard and the satellite and the distance between the satellite and Sophie are the same, which is approximately 36; 000 km. The satellite acts as a transponder (a repeater). Assume that the processing time at transmitter, satellite and receiver, and the transmission time for the acknowledgment frame are all negligible. Due to the good error correction code in the frame, you could assume that the channel error rate is negligible. We de ne channel efficiency as:

(x frame transmission times)/ (total time spent for transmitting x frames) ,

where x can be any positive integer. The speed of light is 3x 10^8 meter per second.

a. If the Stop and Wait ARQ Protocol is used, what is the channel efficiency?
b. If the sliding window ARQ protocol is used with receiving window size equal to 1, the sequence number field in the frame is 3 bits long, what is the channel efficiency if the maximum sending window size is used?
c. If the sliding window ARQ protocol is used with receiving window size equal to sending window size, the sequence number field in the frame is 3 bits long, what is the channel efficiency if the maximum sending window size is used?
d. If the sequence number field in the frame is 8 bits long, answer (b) and (c).

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

You know the right answer?

A 50 kbps satellite channel is used to transmit 1000-bit frames between Sophie in Moscow and Richard...

Questions