Engineering, 25.02.2020 23:18 mvasquez3122p4vahv

A Dual cycle engine is analyzed using the cold air standard method. Given the conditions at state 1, compression ratio (r), and cutoff ratio (rc) determine the efficiency and other values listed below.
Note: The specific heat ratio and gas constant for air are given as k=1.4 and R=0.287 kJ/kg-K respectively.

--Given Values--
T1 (K) = 328
P1 (kPa) = 190
r = 14
rp = 1.3
rc = 1.3

a) Determine the specific internal energy (kJ/kg) at state 1.
b) Determine the temperature (K) at state 2.
c) Determine the pressure (kPa) at state 2.
d) Determine the specific internal energy (kJ/kg) at state 2.
e) Determine the temperature (K) at state 3.
f) Determine the pressure (kPa) at state 3.
g) Determine the specific internal energy (kJ/kg) at state 3.
h) Determine the specific enthalpy (kJ/kg) at state 3.
i) Determine the temperature (K) at state 4.
j) Determine the pressure (kPa) at state 4.
k) Determine the specific enthalpy (kJ/kg) at state 4.

l) Determine the temperature (K) at state 5.

m) Determine the pressure (kPa) at state 5.

n) Determine the specific internal energy (kJ/kg) at state 5.

o) Determine the net work per cycle (kJ/kg) of the engine.

p) Determine the heat addition per cycle (kJ/kg) of the engine.

q) Determine the efficiency (%) of the engine.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:20

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

Answer

You know the right answer?

A Dual cycle engine is analyzed using the cold air standard method. Given the conditions at state 1,...

Questions