A column in a building is subjected to the following load effects:
9 kips compression f...
Engineering, 25.02.2020 22:30 khaz1430
A column in a building is subjected to the following load effects:
9 kips compression from dead load.
5 kips compression from roof live load.
6 kips compression from snow.
7 kips compression from.
3 inches of rain accumulated on the roof.
8 kips compression from wind
a. If load and resistance factor design is used, determine the factored load (required strength) to be used in the design of the column. Which AISC load combination controls?
b. What is the required design strength of the column?
c. What is the required nominal strength of the column for a resistance factor phi of 0.90?
d. If allowable strength design is used, determine the required load capacity (required strength) to be used in the design of the column. Which AISC load combination controls?
e. What is the required nominal strength of the column for a safety factor Ohm of 1.67?
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
Engineering, 04.07.2019 19:10
In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?
Answers: 3
You know the right answer?
Questions
Mathematics, 12.12.2020 16:40
Business, 12.12.2020 16:40
English, 12.12.2020 16:40
Mathematics, 12.12.2020 16:40
Social Studies, 12.12.2020 16:40
Chemistry, 12.12.2020 16:40
Mathematics, 12.12.2020 16:40
