You have a Co-Cr alloy with Young's Modulus: 645 MPa, Poisson ratio 0.28, and yield strength 501 MPa for that alloy when used in a medical device. From these data estimate the following for a 1 x 2 cm cross-section bar of the alloy having length 12 cm.

a. The maximum tensile load that can be applied in the longitudinal direction of the bar without inducing plastic deformation.
b. The length and cross-sectional area of the bar at its tensile elastic limit.

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

What is the main objective of using reheat rankine cycle?

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?