Engineering, 25.02.2020 17:18 lex3340
The anchor shown is used to tie tower guy cables to the ground and is supported by a distributed force from the soil, which can be approximated as shown. The anchor also is subjected to the loads shown, where P1 = 5 kNand P2 = 3 kN . The anchor is made from aluminum with E = 69 GPa . It is a cylindrical rod with diameter d1 = 4 cm with three segments of length L = 2 m . One end of the rod is linearly tapered to a diameter of d2 = 2 cm.
a. Calculate the intensity of the reaction load, Po
b. Use the reaction found in Part A, po = 13 kN/m , and calculate the total change in length for the anchor.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
You know the right answer?
The anchor shown is used to tie tower guy cables to the ground and is supported by a distributed for...
Questions
Mathematics, 23.06.2019 09:30
History, 23.06.2019 09:30
Geography, 23.06.2019 09:30
History, 23.06.2019 09:30
Chemistry, 23.06.2019 09:30
History, 23.06.2019 09:30
