Engineering, 24.02.2020 19:02 chloegirl9796

A small can containing compressed air at sufficiently high pressure can be used to reinflate a flat car tire. If the initial temperature of both the compressed air and the air in the tire is 70 F, estimate the initial pressure in the compressed air can necessary to reinflate one tire from 0 psig (14.7 psia) to 23 psig (37.7 psia). Also, estimate the final air temperature in the tire and in the can. Assume the following:
a) Air is an ideal gas with CV=5.014 BTU/lb-mol Rankine (R=1.99 BTU/lb-mol Rankine).
b) The tire does not change size or shape during the inflation process.
c) The inner tube of the tire has a volume of 1.5 ft3.
d) The compressed air can has a volume of 0.022 ft3.
e) The can is disconnected from the tire as soon as the pressure in the tire is the same as that in the can. Since this happens rapidly relative to thermal equilibration, assume that the air in the can expands adiabatically and reversibly

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

You know the right answer?

A small can containing compressed air at sufficiently high pressure can be used to reinflate a flat...

Questions