Engineering, 22.02.2020 04:01 ADKREBS

Describe why mixtures of liquids and gases, even of the same substance, are NOT ideal gases. Describe which assumptions this mixture violates and draw plots comparing the behavior of these gases on P-v and T-v plots to support your argument. Water in a piston-cylinder system undergoes an isobaric heat addition process. It starts as a saturated liquid at 438.1 K (state 1) and then heat is added. Make sure to indicate the table you used for each of the questions below. What is the enthalpy at state 1? What is the enthalpy when the water reaches a saturated vapor state? What is the enthalpy when the water reaches 700 K? What is the phase?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

Describe why mixtures of liquids and gases, even of the same substance, are NOT ideal gases. Describ...

Questions