Engineering, 21.02.2020 20:21 elawnnalewis3568

Rigid bar BCD is supported by a pin at C and by aluminum rod (1). A concentrated load P is applied to the lower end of aluminum rod (2), which is attached to the rigid bar at D. The cross-sectional area of each rod is A = 0.20 in.2 and the elastic modulus of the aluminum material is E

= 10900 ksi. After the load P is applied at E, the strain in rod (1) is measured as 1350 με (tension). Assume L1=44 in., b=18 in., a=30 in., and L2=105 in.

Determine the magnitude of load P.

Determine the total deflection of point E relative to its initial position.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

Rigid bar BCD is supported by a pin at C and by aluminum rod (1). A concentrated load P is applied t...

Questions