subject
Engineering, 21.02.2020 01:35 Evilgus4846

Considering the two portal frames below, each with an applied lateral load of 10k, assume the beam and column EI to be the same. Often in design, the building code maximum displacement limit controls the lateral force resisting system design. If the maximum allowed displacement for this load is 2% of the column height, what is the minimum required EI for each frame assuming the frame beam length?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:10
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
question
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
Considering the two portal frames below, each with an applied lateral load of 10k, assume the beam a...
Questions
question
Health, 05.06.2020 00:02
Questions on the website: 13722360