Engineering, 19.02.2020 21:59 DoomydoomGir

The plug has a diameter of 30 mm and fits within arigid sleeve having an inner diameter of 32 mm. Both theplug and the sleeve are 50 mm long. Determine the axialpressure p that must be applied to the top of the plug tocause it to contact the sides of the sleeve. Also, how far mustthe plug be compressed downward in order to do this? Theplug is made from a material for which E = 5 MPa, n = 0.45

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump

Answers: 2

Answer

Engineering, 06.07.2019 04:30

Acylindrical tank is capable of storing 20,000 foot-pounds [ft ibf] of energy for use in your roommate's 2006 subaru wrx. the tank contains nitrous oxide, n20, which you may assume is an ideal gas and has a molecular weight of 44 grams per mole 1g/mol. the tank fits in a space in the trunk that is no wider than 6 inches fin] and no longer than 10 inches [inj, and you may assume the warm clemson weather is keeping the temperature of the tank inside the trunk at a constant 100 degrees fahrenheit [°fl. what is the weight of the nitrous oxide occupying the tank when full, in units of dynes

Answers: 1

Answer

You know the right answer?

The plug has a diameter of 30 mm and fits within arigid sleeve having an inner diameter of 32 mm. Bo...

Questions