ADDI X9 X6 8
ADD X10 X6 XZR
STUR X10 [X9, 0]
LDUR X9, [ X9,0]
ADD X0, X9, X10
For each LEGv8 instruction show the value of the opcode (Op), source register (Rn), and target register (Rd or Rt) fields. For the I-type instructions, show the value of the immediate field, and for the R-type instructions, show the value of the second source register (Rm).

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.