Engineering, 19.02.2020 02:28 garciazzzz6

Carbon resistors often come as a brown cylinder with colored bands. These colored bands can be read to determine the manufacturer's target resistance value. The first two bands (L and M) represent the number. The third band (N) represents the order of magnitude - basically how many zeros to add. The fourth band (S) represents a tolerance. A tolerance of 5% (gold band) means that most resistors will fall within 5% of the labeled value. A silver band represents 10% and no color represents 20%.Black 0brown 1red 2orange 3yellow 4green 5blue 6violet 7gray 8white 9Green (5), Red (2), Red (2) with a silver band would represent a resistor with a resistance of 52e2 ohms, which is 5200 ohms or 5.2 kohms. The tolerance would be 10%.What would be the resistance and tolerance for the following two cases?a) Yellow, Violet, Red, Gold:b) Red, Black, Green, nothing:

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

Carbon resistors often come as a brown cylinder with colored bands. These colored bands can be read...

Questions