subject
Engineering, 18.02.2020 21:45 kay4358

One challenge for architects is that the design created today will require several years of implementation, verification, and testing before appearing on the market. This means that the architect must project what the technology will be like several years in advance. Sometimes, this is difficult to do. a) According to the trend in device scaling historically observed by Moore’s law, the number of transistors on a chip in 2028 should be how many times the number in 2018? (You may assume a 40% increase in the number of transistors per year.)b) The increase in performance once mirrored this trend. Had performance continued to climb at the same rate as in the 1990s, approximately what performance would chips have over the VAX-11/750 in 2028 (assume a 40% increase in performance per year)? You may assume that the speedup in the year 2003 over the VAX-11/750 is 6043x. c) At the current rate of increase of the mid-2000s (assume 22% per year), what is a more updated projection of performance in 2028? You may assume that the speedup in the year 2010 over the VAX-11/750 is known to be 24,129.d) What has limited the rate of growth of the clock rate, and what are architects doing with the extra transistors to increase performance?e) The rate of growth for DRAM capacity has also slowed down. For 20 years, DRAM capacity improved 60% each year. If 8 Gbit DRAM was first available in 2015 and 16 Gbit DRAM was not available until 2019, what is the current DRAM growth rate?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
One challenge for architects is that the design created today will require several years of implemen...
Questions
question
Mathematics, 21.06.2019 12:50
question
Mathematics, 21.06.2019 13:00
Questions on the website: 13722361