subject
Engineering, 14.02.2020 21:37 alexussaniyah

Below are four kinetic expressions (mathematical models), which have been proposed to simulate coliform die - away during the disinfection of wastewater. Given the batch laboratory data in the table below, which of the four models best describes the coliform die - away? Linearize the equations and make four graphical presentations of the linearized equation and the laboratory data.
a. dC/dt =-k1C
b. dC/dt = -k2C2
c. dC/dt = -k3CX where, X is the concentration of the chlorine disinfectant,
d. dC/dt = -k4Ct where, C is the concentration of the coliform bacteria (colony forming units, cfu/mL) and is t (min)
For the best model, report the rate constant that you obtained from your plot.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
You know the right answer?
Below are four kinetic expressions (mathematical models), which have been proposed to simulate colif...
Questions
question
Chemistry, 20.10.2020 01:01
question
English, 20.10.2020 01:01
Questions on the website: 13722367