Engineering, 14.02.2020 04:46 22savage2017

A circular steel [α = 6.5 × 10−6/°F] band is to be mounted on a circular steel drum. The outside diameter of the drum is 50 in. The inside diameter of the circular band is 49.95 in. The band will be heated and then slipped over the drum. After the band cools, it will grip the drum tightly. This process is called shrink fitting. If the temperature of the band is 72°F before heating, compute the minimum temperature to which the band must be heated so that it can be slipped over the drum. Assume that an extra 0.05 in. in diameter is needed for clearance so that the band can be easily slipped over the drum. Assume that the drum diameter remains constant.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 06.07.2019 03:20

Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.

Answers: 2

Answer

Engineering, 06.07.2019 04:10

An inventor claims to have developed a reversed heat engine (ie. a heat pump) which is able to deliver 10 kj heat into the room at 20°c from outside ambient temperature of -10°c by consuming only 2 kj electricity in winter. this claim is a)-impossible b)-possible only if the heat pump is ideal c)-practically possible d)-unable to be assessed as it depends on the working fluid used in the heat pump.

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Agas mixture with a compostion of 55 methane, 30% propane, and 15 butane by volume) is compressed from 1 bar and 25°c to 9bar in a compressor with an isentropic efficiency of 85%. the environment has a temperature of to25 c. determine (a) the exit temperature of the mixture (b) the specific work required to run the compressor (c) the specific entropy generation of the process (d) the specific exergy destruction of the process (e) the second law efficiency of the compressor

Answers: 3

Answer

You know the right answer?

A circular steel [α = 6.5 × 10−6/°F] band is to be mounted on a circular steel drum. The outside dia...

Questions