subject
Engineering, 14.02.2020 03:50 shanua

Early American rockets used an RC circuit to set the time for the rocket to begin re-entry after launch (true story). Assume the capacitor is initially charged, and then discharge begins at launch, t = 0 (this was when the umbilical connector was disconnected). Further assume the resistor in the RC circuit is 1k Ī©, and the control circuit begins re-entry when the voltage drops ~63% or to ~37% of full-scale (i. e. 1 time constant), and re-entry is desired to commence at 5 minutes (i. e. 300 seconds after launch). Calculate the capacitor value required.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Early American rockets used an RC circuit to set the time for the rocket to begin re-entry after lau...
Questions
question
English, 19.02.2021 01:00
question
Mathematics, 19.02.2021 01:00
question
Mathematics, 19.02.2021 01:00
question
English, 19.02.2021 01:00
question
Mathematics, 19.02.2021 01:00
question
English, 19.02.2021 01:00
question
Mathematics, 19.02.2021 01:00
question
Mathematics, 19.02.2021 01:00
Questions on the website: 13722361