Engineering, 12.02.2020 05:19 Tyrant4life

A flight consultant wishes to model the process by which an airplane allows any charge build-up acquired in flight to leak off. She is aware that planes have needle shaped metal extensions on the wings and tail to accomplish this and that the process works, because the electric field around the needle is much larger than around the body of the plane, causing dielectric breakdown of the air and discharging the plane. Her model consists of two conducting spheres connected by a conducting wire. The sphere representing the plane has a radius of 6.00 m, the sphere representing the tip of the needle has a radius of 2.00 cm, and a total charge of 78.0 µC is placed on the combination.
(a) Determine the electric potential (in V) at the surface of each sphere.
(b) Determine the electric field (in V/m) at the surface of each sphere.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

You know the right answer?

A flight consultant wishes to model the process by which an airplane allows any charge build-up acqu...

Questions