Engineering, 12.02.2020 04:57 havennn
A highway reconstruction project is being undertaken to reduce crash rates. The reconstruction involves a major realignment of the highway such that a 60mph design speed is attained. At one point on the highway, a 720-ft equal tangent crest vertical curve exists. Measurements show that 3 40 stations from the PVC, the vertical curve offset is 3.5ft. Assess the adequacy of this existing curve in light of the reconstruction design speed of 60mph and, if the existing curve is inadequate, compute a satisfactory curve length.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:20
Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k
Answers: 2
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
You know the right answer?
A highway reconstruction project is being undertaken to reduce crash rates. The reconstruction invol...
Questions
English, 30.03.2020 22:59
Computers and Technology, 30.03.2020 22:59
Mathematics, 30.03.2020 22:59
Mathematics, 30.03.2020 22:59
Social Studies, 30.03.2020 22:59
Computers and Technology, 30.03.2020 22:59
Biology, 30.03.2020 22:59
