Engineering, 11.02.2020 22:56 xojade

You are given a piece of material (you suspect it's a semiconductor but are not sure) and know nothing about it (except that it looks transparent to the eye).

a. What is the minimum band gap energy that you expect this material to have?
b. Describe an experiment to determine its conductivity. Be specific about details: set up, what equipment is used to measure each variable, and plot the data you expect to get.
c. Describe an experiment (or set of experiments) to determine its energy gap, electron affinity, and ionization potential. Be specific as in b.
d. From the above experiments, how can you be sure it's a semiconductor and not a metal?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

You know the right answer?

You are given a piece of material (you suspect it's a semiconductor but are not sure) and know nothi...

Questions