Engineering, 11.02.2020 20:57 ella3714

Find the value of R2 required if vs = 18 V , R1 = 50 kΩ , and the desired no-load output voltage is vo = 6 VPart b)Several different loads are going to be used with the voltage divider from Part A. If the load resistances are 300 kΩ , 200 kΩ , and 100 kΩ , what is the output voltage that is the most different from the design output voltage vo = 6 V ?part c)The circuit designer wants to change the values of R1 and R2 so that the design output voltage vo = 6 V is achieved when the load resistance is RL = 200 kΩ rather than at no-load. The actual output voltage must not drop below 5.4 V when RL = 100 kΩ . What is the smallest resistor value that can be used forR1?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

Find the value of R2 required if vs = 18 V , R1 = 50 kΩ , and the desired no-load output voltage is...

Questions