Engineering, 11.02.2020 19:25 officialgraciela67

The following equation occurs in the solution of certain vibrations problems involving a constant cross-section beam with an end load, f(x) cx cot(x). It is necessary to find several, often hundreds, of the roots of this equation in computations of vibrational response of a given system. You are to find the first 25 positive roots of this equation using the bisection method. Write a MATHCAD program to accomplish this task. Taking c = 0.375
1. plot cot(x) and cx versus x.
2. use the results from the above plot to determine bracketing values for each of the first 25 positive roots of f(x)=0.
3. set the maximum error in determining the root to 10-5 and compute all 25 roots using five decimal places.
4. compare your results to those obtained by using the intrinsic root finding function in either MATHCAD or MATLAB.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

The following equation occurs in the solution of certain vibrations problems involving a constant cr...

Questions