Engineering, 08.02.2020 03:40 4300224102
Create a class called time that includes three instance variablesā hours (type int), minutes (type int) and seconds (type int). provide a constructor that initializes the three instance variables. provide a set and a get method for each instance variable. provide a method displaytime that displays the hours, minutes and seconds separated by colons (: ). write a test application named timetest that demonstrates class timeās capabilities. (the numbers should be valid for hours, minutes, seconds, assume 24hrs display.) ex: 78: 23: 99 is not valid., 18: 25: 55 is valid,
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 Ā°f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Create a class called time that includes three instance variablesā hours (type int), minutes (type i...
Mathematics, 29.04.2021 18:30
Physics, 29.04.2021 18:30
Geography, 29.04.2021 18:30
Computers and Technology, 29.04.2021 18:30
Mathematics, 29.04.2021 18:30
Mathematics, 29.04.2021 18:30
Chemistry, 29.04.2021 18:30
Mathematics, 29.04.2021 18:30
English, 29.04.2021 18:30
Mathematics, 29.04.2021 18:30
Mathematics, 29.04.2021 18:30
Mathematics, 29.04.2021 18:30