subject
Engineering, 05.02.2020 21:50 ICAMARON5070

Awell-insulated rigid tank is divided into two regions by a movable partition through which heat can flow via conduction. in the left region air exists with the following properties (2 kg, 5 bar, 350 k). in the right region co exists with the following properties (4 kg, 2 bar, 450 k). a pin holds the partition in place. the pin is removed and the air and co achieve pressure and temperature equilibrium. use a control volume that includes the air, the co and the partition. neglect the mass of the partition. a. assume constant specific heat for both air and co. look up the necessary specific heat values at an estimated average temperature of 400 k. b. determine the final temperature. c. using a new, more accurate, average air temperature and a new, more accurate, average co temperature, estimate how far off, in percent, the original specific heat estimates at 400 k are.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
You know the right answer?
Awell-insulated rigid tank is divided into two regions by a movable partition through which heat can...
Questions
question
Mathematics, 08.02.2021 18:30
question
Mathematics, 08.02.2021 18:30
Questions on the website: 13722363