Engineering, 28.01.2020 05:31 payshencec21
The turbine in both cases at 5 mpa as a saturated vapor, and the condenser pressure is 50 kpa. in the rankine cycle, the condenser exit state is saturated liquid and in the carnot cycle, the boiler inlet state is saturated liquid. draw the t-s diagrams for both cycles.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
The turbine in both cases at 5 mpa as a saturated vapor, and the condenser pressure is 50 kpa. in th...
Questions
Mathematics, 11.03.2020 03:05
History, 11.03.2020 03:05
Biology, 11.03.2020 03:05
Mathematics, 11.03.2020 03:05
