subject
Engineering, 28.01.2020 01:31 deshawnnash53

Given a = v1(t) = 4 cos(377t + 17Β°) v and b = v2(t) = –20 cos 377t v. report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees.

the signal (click to select) v leads (click to select) by

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
You know the right answer?
Given a = v1(t) = 4 cos(377t + 17Β°) v and b = v2(t) = –20 cos 377t v. report your answer so the mag...
Questions
question
Biology, 08.03.2021 06:00
question
Mathematics, 08.03.2021 06:00
question
Computers and Technology, 08.03.2021 06:00
question
Mathematics, 08.03.2021 06:00
question
Mathematics, 08.03.2021 06:00
Questions on the website: 13722361