![subject](/tpl/images/cats/User.png)
Engineering, 27.01.2020 22:31 choiboiqg5755
Air at 40°c flows over a long, 25-mm-diameter cylinder with an embedded electrical heater. in a series of tests, measurements were made of the power per unit length, p’, required to maintain the cylinder surface temperature at 300°c for different free stream velocities u of the air. the results are as follows:
air velocity, u (m/s) 1 2 4 8 12
power, p’ (w/m) 450 658 983 1507 1963
(a) determine the convection coefficient for each velocity, and display your results graphically.
(b) assuming the dependence of the convection coefficient on the velocity to be of the form h = cu n , determine the parameters c and n from the results of part (a)
![ansver](/tpl/images/cats/User.png)
Answers: 1
Another question on Engineering
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 19:10
Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.
Answers: 2
You know the right answer?
Air at 40°c flows over a long, 25-mm-diameter cylinder with an embedded electrical heater. in a seri...
Questions
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 18:31
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 18:31
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 18:31
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 18:31
![question](/tpl/images/cats/obshestvoznanie.png)
Social Studies, 17.12.2019 18:31
![question](/tpl/images/cats/himiya.png)
Chemistry, 17.12.2019 18:31
![question](/tpl/images/cats/istoriya.png)
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/himiya.png)
Chemistry, 17.12.2019 18:31
![question](/tpl/images/cats/istoriya.png)
History, 17.12.2019 18:31
![question](/tpl/images/cats/mir.png)
World Languages, 17.12.2019 18:31
![question](/tpl/images/cats/biologiya.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 18:31
![question](/tpl/images/cats/obshestvoznanie.png)
![question](/tpl/images/cats/en.png)
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 18:31
![question](/tpl/images/cats/informatica.png)
Computers and Technology, 17.12.2019 19:31
![question](/tpl/images/cats/mat.png)
Mathematics, 17.12.2019 19:31