Engineering, 25.01.2020 04:31 mem8163

Assume a strain gage is bonded to the cylinder wall surface in the direction of the hoop strain. the strain gage has nominal resistance r0 and a gage factor gf. it is connected in a wheatstone bridge configuration where all resistors have the same nominal resistance; the bridge has an input voltage, vin. (the strain gage is bonded and the wheatstone bridge balanced with the vessel already pressurized.)calculate the voltage change ∆v across the wheatstone bridge when the cylinder is pressurized to ∆p = 2.5 atm. assume the vessel is made of 3004 aluminum with height h = 21 cm, diameter d = 9 cm, and thickness t = 65 µm. the gage factor is gf = 2 and the wheatstone bridge has vin = 6 v. the strain gage has nominal resistance r0 = 120 ω.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

Assume a strain gage is bonded to the cylinder wall surface in the direction of the hoop strain. the...

Questions