Engineering, 25.01.2020 03:31 harveyangel123p2tjae

Exactly 5.00 ml aliquots of a solution containing phenobarbital were measured into 50.00ml volumetric flasks and made basic with koh.
the following volumes of a standard solution of phenobarbital containing 2.00 µg/ml of phenobarbital were then introduced into each flask and the mixture was diluted to volume: 0.00, 0.500,1.000, 1.50, and 2.00ml.
the fluorescence of each of these solutions was measured with a fluorometer, which gave volumes of 3.26, 4.80, 6.41, 8.02, and 9.56 respectively.

(a) pot the data.
(b) using the plot from (a) calculate the concentration of phenobarbital in the unknown.
(c) derive a least-squares equation for the data.
(d) find the concentration of phenobarbital from the equation in (c)
(e) calculate a standard deviation for the concentration obtained in (d)

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

You know the right answer?

Exactly 5.00 ml aliquots of a solution containing phenobarbital were measured into 50.00ml volumetri...

Questions