Engineering, 21.01.2020 03:31 10040816
The two 2-kg gears a and b are attached to the ends of a 5-kg slender bar. the gears roll within the fixed ring gear c, which lies in the horizontal plane. if a 10-n*m torque is applied to the center of the bar as shown, determine the number of revolutions the bar must rotate starting from rest in order for it to have an angular velocity of w_ab = 20 rad/s. for the calculation, assume the gears can be approximated by thin disks. what is the result if the gears lie in the vertical plane?
Answers: 1
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
The two 2-kg gears a and b are attached to the ends of a 5-kg slender bar. the gears roll within the...
Mathematics, 01.12.2020 15:40
Physics, 01.12.2020 15:40
Arts, 01.12.2020 15:40
Mathematics, 01.12.2020 15:40
Chemistry, 01.12.2020 15:40
Chemistry, 01.12.2020 15:40
Mathematics, 01.12.2020 15:40
English, 01.12.2020 15:40
Social Studies, 01.12.2020 15:40
French, 01.12.2020 15:40
Arts, 01.12.2020 15:50