Engineering, 20.01.2020 19:31 StephenCurry34
I"powered up" my circuit by connecting it to the live terminals of a power supply. i then measured the resistance of a resistor in my circuit and wound up with an unexpected value. i therefore concluded that the resistor was out of tolerance, so i removed it from the circuit. did i do something wrong? was the resistor really out of tolerance?
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
I"powered up" my circuit by connecting it to the live terminals of a power supply. i then measured t...
Questions
English, 28.12.2020 01:00
History, 28.12.2020 01:00
Social Studies, 28.12.2020 01:00
Mathematics, 28.12.2020 01:00
English, 28.12.2020 01:10
Biology, 28.12.2020 01:10
English, 28.12.2020 01:10
Advanced Placement (AP), 28.12.2020 01:10
Mathematics, 28.12.2020 01:10
English, 28.12.2020 01:10
Mathematics, 28.12.2020 01:10
Business, 28.12.2020 01:10
Health, 28.12.2020 01:10
