subject
Engineering, 17.01.2020 08:31 wisal96

Ajar made of 3/16-inch-thick glass has an inside radius of 3.00 inches and a total height of 6.00 inches (including the bottom thickness of glass). the glass has a density of 165 lb/ft3. the jar is placed in water with a density of 62.5 lb/ft3.
assume the jar sits upright in the water without tipping over. how far will the empty jar sink into the water?

what is the volume of the glass shell of the jar? precision 0.00

what is the weight of the jar? precision 0.00

what is the weight of water the empty jar will displace? precision 0.00

what is the volume of water the empty jar will displace? precision 0.00

how far will the empty jar sink?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Ajar made of 3/16-inch-thick glass has an inside radius of 3.00 inches and a total height of 6.00 in...
Questions
question
Mathematics, 06.11.2019 19:31
question
Mathematics, 06.11.2019 19:31
Questions on the website: 13722362